Brewing in a cask

Post #1 made 13 years ago
I have a cask.

Obviously it has a large hole in the side that needs welding. Has anyone seen these converted for BIAB?

I have the ripple 5.5kw element. I'm not entirely sure it's going to fit in there...

Worse comes to worse I do have a large aluminium pot, but it's quite shallow. I'm installing a 30A line to the garage for this btw... No faffing with the dodgy electrics in the house, fresh new line!

Post #2 made 13 years ago
Sorry you haven't had any replies here yet Tim :sad:.

My guess is that a lot of guys might be confused on what a cask is as it can have different meanings in different countries. I'm guessing you mean a small aluminium keg but I'm not really sure. Can you post a pic and give some sizes?

That should give enough info to the electric brewers her to help you out.

:luck:
If you have found the above or anything else of value on BIABrewer.info, consider supporting us by getting some BIPs!
    • SVA Brewer With Over 100 Brews From Australia

Post #3 made 13 years ago
I know what a cask is (being a fan of real ale) but have never seen one "up close and personal". Perhaps a few pictures would help us assess the situation.

---Todd
WWBBD?
    • SVA Brewer With Over 100 Brews From United States of America

Brewing in a cask

Post #4 made 13 years ago
Hi - it's got magnetic results so I'm assuming it's steel. I may yet go down the route of using a pot.

Just laid in the 10mm cable from the fuse box to the garage. Bought 25m, should have got 15... Never mind

Drilled a couple of holes in my weatherboarding, ran the cable out of the roof, through my lean to. Then drilled a diagonal hole through the corner of the garage.

I've got my friend (electrician) coming over to do the actual wiring in. I don't trust my wiring on 32A lines.
Post Reply

Return to “Electric BIAB”

Brewers Online

Brewers browsing this forum: No members and 8 guests