Search found 11 matches

Go to advanced search

Display posts from previous
Sort by

Joshua, you are correct about the single tube up the center. It's main purpose (IMO) is to exhaust the CO2 and residue heat up and out to a safe place. But it will indeed have an affect on heating the water. I saw the mention of "many" tubes and just wanted to clarify that I was talking about hot wa...

Hummm that is a lot different/updated than the calculator that I down loaded today off the site. I guess the US/English column I added was a waste of time, as it is already done now. I understood the strike temp after the grains were added, my question was, where to get the water temp up to to compe...

OK, I understand everyone concerns. I think I saved one from my own hot water heater several years back, I will see if I can find it. It was cast iron, and about 10 inch circle burner (much like a turkey fryer). Our tanks here in the US are just large tall cylinders w/o any holes going through. Thes...

Heck, you could skip the electronics and use simple bicycle brake cables and have pull knobs. Just spring load the levers back at the picnic keg dispensers. And you have compressed CO2, you can also drive small pneumatic cylinders to actuate the picnic levers too. Lots-O-Ways to skin that cat....:sh...

OK, so this thread was eating at me after I posted my last post. Even what I suggested above is still a difficult task. So how about this as an idea. I did not actually select the "actual" parts and model everything up in SolidWorks because were all in very different parts of the world and you guys/...

seems like with a little mods this could be fitted quickly http://www.lowes.com/pd_94614-63872-1270_5003716__?productId=3475295&Ntt=Metal+trash+can&pl=1¤tURL=%2Fpl_0%2B1_5003716__s%3FNtt%3DMetal%2Btrash%2Bcan&facetInfo=0%20-%201 http://www.lowes.com/pd_94614-63872-1270_5003716__?productId=3475...

This might be getting long in the tooth (on the original subject), but why not stick with the original single manifold idea with 4 to 8 ball valves and machine up a large block of (insert you favorite metal here, Copper, Brass, SS, whatever) materiel to accept those ball valves. Then cool the unit w...

Go to advanced search