5.5kw, PID temperature control @ boil point

Post #1 made 12 years ago
Last weekend when I made some sweet, sweet beer nectar, I used the PID to get to strike temperature, but when I got to boil everyone says 'switch the pid to manual mode'

I found that to maintain a proper temperature, I had to have the PID constantly heating. It may be due to the ambient temperature being between 4-7'C and the "extractor fan" (a freestanding fan I found in a skip that blows the steam out the garage doors) keeping it cooler than it would normally be.

Is this normal?

Post #2 made 12 years ago
Not sure, I would say some more investigation may be in order? I run a single 220V 5500watt element in a 20 gallon pot and on a recent brew day in the garage at 6C ambient it maintained a boil in manual mode at 68% power setting. What PID do you have?

---Todd
WWBBD?
    • SVA Brewer With Over 100 Brews From United States of America

Post #3 made 12 years ago
Same as you Todd I think! An Auber SYL-2352

I get a good rolling boil, I assume it's not supposed to be simmering! Using the BIABacus it runs by the numbers in terms of evaporation etc.

Post #4 made 12 years ago
There is also a setting somewhere that needs to be correct for the PID to cycle properly on manual mode. I believe I have it scribbled down somewhere at home (drove me nuts for a while until I figured it out). I will make a note-to-self and check my notes at first opportunity (probably can't get to it until Friday though...sorry).

---Todd
WWBBD?
    • SVA Brewer With Over 100 Brews From United States of America

Post #5 made 12 years ago
Found it! The Hysteresis Band (HY setting) needs adjusting from the default of 3 down to 1. With the default setting of 3, in manual mode, there is way too much delay in cycling the element and you need to have it set to 100% to boil. After adjusting the HY value to 1, you should be able to use the manual mode effectively and will find that 65-70% should give you a good rolling boil.

---Todd
WWBBD?
    • SVA Brewer With Over 100 Brews From United States of America

Post #7 made 12 years ago
100% power on my rig will blow the liquid right out of the kettle! 65-70% gives the desired vigorous rolling boil.
Last edited by thughes on 31 Jan 2014, 01:11, edited 1 time in total.
WWBBD?
    • SVA Brewer With Over 100 Brews From United States of America

Post #8 made 12 years ago
thughes wrote:100% power on my rig will blow the liquid right out of the kettle! 65-70% gives the desired vigorous rolling boil.
ah fair enough! I have a 70ltr pot and when doing a 5g brew it's only about half full.
Last edited by tim_n on 31 Jan 2014, 02:45, edited 1 time in total.
Post Reply

Return to “Electric BIAB”

Brewers Online

Brewers browsing this forum: No members and 4 guests